Publish reproducible figures and exports

A reproducible figure records which solution and expression it shows, not just a useful camera angle.

1. Run the intended study and select its completed data under Results. For a transient, sweep or modal result, choose the relevant time, parameter point or mode.
2. Select a plot group and expression. Review units, color scale and any deformation factor, then click Plot.
3. Save a named simulation camera if the same framing is needed again. A camera changes appearance, not the numerical solution.
4. Export the published image or selected data. Reopen the output to confirm its content and label the study, data selection and units.

Rerun and replot after changing physical inputs. A previous successful plot can remain visible while a later operation fails.